diff options
Diffstat (limited to 'README.md.orig')
| -rw-r--r-- | README.md.orig | 56 |
1 files changed, 0 insertions, 56 deletions
diff --git a/README.md.orig b/README.md.orig deleted file mode 100644 index f1353ef..0000000 --- a/README.md.orig +++ /dev/null @@ -1,56 +0,0 @@ -# Linux kernel module for the Thrustmaster T300RS wheel - -## Current state -Playable. Dynamic updating of effects isn't baked into the wheel quite as -well as I'd hoped, and so the driver in its current state doesn't really -support it. At some point in the future I'd like to add it to the feature -list, but it will need a lot more research and might take a while. - -One other issue is that if you have the T3PA pedals, the clutch doesn't seem -to be registered by most(all?) games. It is registered and works as expected -in jstest and jstest-gtk, no clue what that is about. - -Anycase, **this version is usable in most force feedback games, supports -rangesetting as well as gain and autocentering along with most force feedback effects.** -## Small note - -While I haven't personally come across any crashes or lockups with this -version, I can't promise that they won't occur under any circumstances. - -With that in mind, - -## Installation - -+ Unplug wheel from computer -+ `git clone this-repo` -+ `make` -+ `sudo make install` -+ Plug wheel back in -+ reboot (not strictly necessary, but recommended) - -Done! - -## Additional tidbits - -+ Change range: - -Write a value between 0 and 65535 to -/sys/bus/devices/XXXX:044F:B66E.XXX/range - -+ Change autocenter and gain: - -Use the default evdev ways, i.e. https://www.kernel.org/doc/html/v5.1/input/ff.html - -<<<<<<< HEAD - + Currently there is no support for this driver in oversteer(https://github.com/berarma/oversteer), but ffbwrap(https://github.com/berarma/ffbtools) should work. - + If the wheel has a deadzone in games, you can set up a udev rule: - `/etc/udev/rules.d/99-joydev.rules`: - `SUBSYSTEM=="input", ATTRS{idVendor}=="044f", ATTRS{idProduct}=="b66e" - - RUN+="/usr/bin/evdev-joystick --evdev %E{DEVNAME} --deadzone 0"` - This should make sure that the wheel behaves like you'd want from a - wheel. -======= -+ Currently there is no support for this driver in oversteer(https://github.com/berarma/oversteer). -I opened a pull request to add support(to some degree) for this driver to ffbtools(https://github.com/berarma/ffbtools), but until it gets merged I have a repo here: https://github.com/Kimplul/ffbtools ->>>>>>> 8dcb9edbc14b9709e6b0d8b567211e4252191b1e |